I have designed and produced circuits with the F4 and L4, using plain Eclipse for development and SEGGER J-Link for both development and the ICP fixtures at the line.I have not been successful at getting J-Link Commander to play well with a G431 over...
I am looking at some reference design EVBs with STM32G4xx for Digital Power Conversion, like the predecessor STM32F334.Where I can find them ? Even from thirdy party.Thanks a lot
I've read AN5306 and it has many helpful explanations, but it does a poor job of actually listing which selector values are used to configure each of the multiplexers - especially the mysterious undocumented one that seems to bridge around the VMSEL ...
Hi,I am using the relatively new STM32G4(74).I am currently implementing the OPAMP-abstraction and i am having issues with calibration.The calibration works in general, if the output routing goes to the pin (OPAINTOEN = 0). (n&p is around 15/16)The c...
Is there a way to connect some pins to both ADC and comparator inputs, for example ADC_IN2 and COMP1_INP? It should be possible because they both are inputs.
I'm using STM32G441KBTx and currently have PB4 as an input and PA10 as a separate output.First, if I put only the microcontroller and programming header, put PB4 as an input with a pullup, and configured PA10 as an output. This is what my main looks ...
I want to FDCAN LOOPBACK using STM32G474RE. but i'm not find example. help me please. I don't have much time left. :(
Page 118, Table 38 has "1.78" in Peripheral column instead of TIM1.Page 115, fourth bullet says "... is given in Table 39. The power...". The table number should be 38.
