About SThre

SThre · 2019-12-03

I'm using STM32G441KBTx and currently have PB4 as an input and PA10 as a separate output.First, if I put only the microcontroller and programming header, put PB4 as an input with a pullup, and configured PA10 as an output. This is what my main looks ...

SThre · 2019-12-01

Is there someway to do this with stm32cubeide?For my specific use case I am storing configuration data on last page of flash (currently working on figuring out how to erase it so i can rewrite it in software), but I would also like to be able to conf...

SThre · 2019-02-13

I am using truestudio and cubemx with STM32F103C8T6. I am trying to use canbus. If I connect the cantx and canrx pins on A12 and A11 (as shown in attached cubemx file), I get an output that looks like a can frame, but has peak voltage of 400mV.cubemx...

SThre · 2019-12-04

Thanks, somehow I had tried to write in the initialization commands section, but I hadn't thought to include the word "monitor" in my command, so it only gave errors.

SThre · 2019-02-14

I figured out the problem with voltage too low. Can transceiver wasn't working because power wasn't present, and tx voltage looked like it was slightly below 400mV because my oscilloscope probe was set to 10x attenuation.

User statistics

User Activity

STM32G441KBTx PB4 as input seems to be affected by the PA10 have and have some problems with internal pullups

How to erase flash before programming with STM32CubeIDE [Solved]

STM32F103C8Tx can tx voltage too low and can clock speed

Re: How to erase flash before programming with STM32CubeIDE [Solved]

Re: STM32F103C8Tx can tx voltage too low and can clock speed