Hi !I got some samples of G473CBTx from ST through one of the official distributor, which were populated on prototype boards. I am trying to flash them, but unfortunately stumbled upon the "no STM32 Target found" error. I tried the following. 1. Use ...
Board: NUcleo 64-G474 I just want to read 2 channels of an ADC but am presented with a bewildering array of incredibly confusing options: Ranks, Continuous mode, discontinous mode, number of conversions, oversampling, triggers, etc, etc, etc. The em...
Hello Community,Reaching out to you for feedback on the attached configuration for Vcc on my new STM32 based DAQ board.My objective was to reduce the inductance to the Vcc pins of the MCU (STM32G0B0RET6 64 LQFP package). Hence I clubbed three pins:A)...
I am using STM32G431cbtx and enabling RCC_MCO. Since the STM32G4 supports two pins, PA8 and PG10, PA8 is being used for another function, and I am using PG10 for RCC_MCO. However, when measuring the voltage on pin PG10, it is always high. Can anyone ...
In the datasheet of W25N01GVZEIG,Data program load and quad data program load can transfer up to (2048+64) bytes.(The transfer of data between the controller and the external flash uses DMA)When I try to write 2048 bytes, nothing is written. The same...
I'm a beginner with STM32 and I'm trying to generate a sine waveform using a STM32G4 through the NUCLEO-G431KB board to be exact. I've been looking through tutorials on how to generate a waveform using a STM32G4 board, particularly this tutorial but ...
Hi i plan new design and require activate for example on PA3 ADC1_IN4 and same time COMP2_INP.Is this possible and if yes how sequence to setup HAL LL or direct?EDIT: Renamed from more AF ... only one AF poss.
I am trying to make an API for W25N01 flash. I have seen many post about this flash board and followed them. But they have not solved the problem of me not being able to read the data (so either my write function or read function is incorrect). The w...
Hello.STM32G431CBT6Is it possible to route the output from the comparator to the input of the Timer input? The reference manual says that this is possible, but there is no description. And in the comparator register there are no options for choosing ...
Hi, I'm trying to store some information in flash, I'm attaching the program. The problem arises when I use HAL_FLASH_Program function. Inside the FLASH_WaitLastOperation function (called by HAL_FLASH_Program), the PGSERR+PGAERR bits are set after th...