Posted on September 27, 2017 at 04:43I porting a tsc sample from \STMicroelectronics\STM32F0xx_STMTouch_Lib_V1.1.0\Projects\Examples\STM32F0518_Ex01_3TKeys_EVAL to my STM32F051 project with touch channel IO using PA0/PA1 and PA3 as samplingIO, but i...
Posted on February 07, 2017 at 12:10Hiwhere do I see which STM32 has how many TSC channels? In this document: UM1913 User manual: Developing applications on STM32Cube with STMTouch� touch sensing librarySTM32L083VBTx is not listed!But in STM32CubeMX...
Posted on November 20, 2014 at 10:33 Hello, i try to develop a touch interface with the stm32f051 and want to use the stm32CubeMX Software. I want to do it with an interrupt and have the generated code in my IAR. My question is, where i c...
Posted on April 18, 2016 at 15:18Hi everyone, I'm trying to set up 3 capacitive touch keys using HAL touch sensing controller library but I'm facing some problems. I followed the instructions in AN2869 application note for implementing one sensor us...
Posted on June 02, 2017 at 22:43HelloI'm trying to use TSC of my Nucleo-32 STM32F303 by changing TouchSensing_2touchkeys project of STM32Cube_FW_F3_V1.8.0 . I want to create one touch button and I try both TSC group 3 and TSC group 6 of my board . w...
Posted on April 04, 2017 at 12:44Hi,I am configuring STM32F334 Nucleo board Touch sense through STM32CubeMX. Now I have configured 6 keys (3 each in group 5 and group 6). Channel 1 in both the groups are used as sampling IOs for their respective gro...
Posted on December 06, 2016 at 11:35Hi! I'm using STM32F334R8-Nucleo board and currently working on Touch Sense (TSC). After getting acquisition value from a group, how can I identify which particular key has been pressed among all the keys connecte...
Posted on November 23, 2015 at 23:49Dear ST community,I�m using STM32F072CB, standard peripheral library and �STMTouch_Lib_V1.1.0� the problem is in the Touch library, I copied the example �STM32F0518_Ex01_3TKeys_EVAL� in my working project since it...
Posted on August 28, 2015 at 17:05Hi, I have a problem with the Touch Sense (TSC) module. No matter how I configure it and measure I always get a sawtooth wave added to it with an amplitude of a few percent of the total count. It seems to remain fai...
Posted on March 05, 2015 at 14:17Dear friends, please help.I make a touch switch on the 3 buttons. I use microcontroller STM32L151 and its hardware ''touch sensing''.The challenge is to ''touch switch'' with CR2032 battery (225mAh) worked for severa...