HelloI have a bunch of STM32G030F6 and they are in TSSOP20 package.I used SWD and BOOT0 pins to program L433 and want to do the same on G030F6However, unlike same TSSOP20 package F070F6 has, G030F6 share BOOT0 pin with SWCLK.19th pin of STM32G030F6 i...
Hi,I would like to report 2 bugs.I created a blank new project for STM32G030F6P6. When I try to enable USART1, it says "Unknown conflict". See the attached screenshot.For STM32L452RET6, when I set LSE drive level other than the default with LL driver...
I am learning the stm32 using a stm32g070cbt6 micro controller with custom PCB with keil. When I add an external pull-up to the pa4 pin and use it as an input pin. Nevertheless, when I read the pin, the output is low always, even though on the hardwa...
I'm using the latest 6.7.0 version of STM32CubeMX for generating the code. I'm selecting just the serial wire and the a different timer for tick generation and nothing else. The code generation is completed without any errors. But when I try to compi...
I'm trying to setup an USART for a very small MCU of the STM32G0 family, the MCU it's theoretically being programmed, but the USART is not responding, I configured the MCU just like I did in other projects (of bigger MCUs), I'm not able to find what ...
Hi,I've just tried to set up TIM2 on an STM32G0B1RE in CubeMX like this:The exact purpose shouldn't matter for this question, but the timer is supposed to generate an interrupt when a LOW pulse of a given minimum length is detected on an external sig...
I am developing a STM32 project with STM32G030K6T6 ADC channels but when I start setting the MCU, it allows only 8 ADC convertions (the datasheet describes there are 12 and the system configuration allows to add up to 12 channels) . However, I need a...
I've updated the question as the answer was not suffient.Using version 6.7.0 of STM32CubeMX and I want to set the SPI SCK and MOSI signals to open drain when in master mode. What I can see, this is not possible and I have to manually modify the confi...
Dear allI'm using STM32G070KBT in my product, as it has 4 UARTs.I want to use the 4 UARTs in asynchronous mode, no HW control, UARTs 1 and 2 use RX/TX, while UARTs 3 and 4 use only RX.When defining all those UARTs in STM32CubeMx, I've some warnings t...
There is an error in the ADC LL example projects on STM32G0 (Fw 1.5.1).Initalisation function (MX_ADC1_Init) call function LL_ADC_SetTriggerFrequencyMode()with inadmissible argument LL_ADC_CLOCK_FREQ_MODE_HIGHpermissible arguments are LL_ADC_TRIGGER_...