I have to configure it as a Client. Can please someone help me with the starting guide for the client configuration like how to establish connection with server and how to write attribute to server, everywhere I found only starting guide for server o...
What's the difference between "aci_gatt_update_char_value" and "aci_gatt_write_char_value"?In addition, what is "aci_gatt_write_without_resp"? Is it faster than others to send data?How can I active "aci_gatt_write_without_resp"?, because it is inacti...
How to configure Zigbee and FreeRTOS using CubeMX. Currently the samples under WB55 have two Zigbee and FreeRTOS samples, but for EWARM. Is there a note on how to manually add FreeRTOS to a CubeMX/CubeIDE project for ZigBee. I have an application on ...
Dear Sir・I want to use BLE with B-L4S5I-IOT01A.(FreeROTS)・However, "UM2178" and "Table 1. FreeRTOS ™ porting abstractions" say "not available".B-L4S5I-IOT01A cannot use BLE?Can I use BLE if I create a project with CubeIDE and implement "STM32_Blu...
Some procedure shows to enable HSEM and RF and Middleware -BT enable, But below is the setup try to simulate step by step but unable to enable them. Is there is any document for STEVAL-MKSBOXv1 and STEVAL SSTLKT01V1
Hi,I am a newbie on microcontroller but, I can read / write on the GPIO port and control a servo motor in PWM with a timer.Now, I am starting to play around with ST BLE for control the GPIO port and servo motor.I use: Nucleo-F401RE X-NUCLEO-IDB05A1 ...
