About KHosh.1

KHosh.1 · 2022-02-17

Dear Sir・I want to use NUCLEO-F446RE as a PoC for IoT.・I plan to use alkaline batteries and connect to CH6 PIN4. (3.3V)⇒It is necessary to reduce the current consumption.I investigated with a simple FW.(Use stabilized power source(SPS))Case:Run Mode(...

KHosh.1 · 2021-09-14

Dear Sir・I want to use BLE with B-L4S5I-IOT01A.(FreeROTS)・However, "UM2178" and "Table 1. FreeRTOS ™ porting abstractions" say "not available".B-L4S5I-IOT01A cannot use BLE?Can I use BLE if I create a project with CubeIDE and implement "STM32_Blu...

KHosh.1 · 2022-11-20

The documentation says this, so I'm asking.A full configured RPi image is provided by ST. Please get the OTBR_CLI_RPi_1.0.img.Regards

KHosh.1 · 2022-11-16

I want to build this demo too.Please attach OTBR_CLI_RPi_1.0.img here.Or. . . Please give me some information.Can I create an RPi RCP image with the following steps?https://openthread.io/guides/border-router/raspberry-piRegards

KHosh.1 · 2021-10-03

Dear sirsolved.I set the attached image.I confirmed that BLE works with B-L4S5I-IOT01A.Thank you for the information.Regard.

KHosh.1 · 2021-09-30

Dear Sir>hci_send_req was timing out.⇒It just didn't generate the source correctly.　(hci_ti_interface.c was not implemented)　I configured it like the attached image.　When communicating with SPBTLE-RF module using SPI3 with B-L4S5I-IOT01A, is this i...

KHosh.1 · 2021-09-29

Dear SirAdditional information>・Does B-L4S5I-IOT01A also need FW Update?⇒hci_send_req was timing out.　　I'm not using flashUpdater. Is it related?Regard.

User statistics

User Activity

About NUCLEO-F446RE current consumption

About B-L4S5I-IOT01A BLE

Re: STM32WB Thread-RCP and Raspberry Pi 3B for Border Router feature.

Re: STM32WB Thread-RCP and Raspberry Pi 3B for Border Router feature.

Re: About B-L4S5I-IOT01A BLE

Re: About B-L4S5I-IOT01A BLE

Re: About B-L4S5I-IOT01A BLE