Ask questions and find answers on ST MEMS sensors, such as the LSM6DSV and the LSM6DSL. Learn how to use the SensorTile.Box, and STEVAL kits.
We are using the VL53L0X sensors in their default configuration supplied out of the factory. We run VL53L0X_DataInit() on the sensors and then every 100ms call VL53L0X_PerformSingleRangingMeasurement(Device, &measure). Upon return, we check measure.R...
We tried to use VL53L0X_CHECKENABLE_RANGE_IGNORE_THRESHOLD.But not found any effect on measurement reading.If you share some input for way to use VL53L0X_CHECKENABLE_RANGE_IGNORE_THRESHOLD, then it will be very useful.
Hello. I would like to measure the level of water in a closed container.I have chosen VL6180V1 for the same since it has an 850 nm light source which won't be absorbed by water.I have referred this article for it:https://community.st.com/s/question/0...
Hi, what are the formula for RMS acceleration and RMS velocity respectively? As I found that there is a Lambda and Tau for RMS velocity and RMS acceleration respectively. Please advise. Thanks!
I have just bought the SensorTile.Box and, as the person posting this question 2 years ago ( https://community.st.com/s/question/0D50X0000BMFuNjSQL/jtag20-to-stdc14-adapter-from-st-for-sensortilebox ), I expected an adapter included in the kit, as I ...
How can I correct the temperature? Is there a correction table?
I am working on improving the pedometer functionality on a sensortile.box device. I would like to use the regression tool provided in the Unico GUI, to use pre-recorded data patterns to configure the pedometer. The problem I ran into is, that if I lo...
I am using a LIS3DH breakout board that is exhibiting weird behavior. My I2C master is a STM32L496 board that has been tested OK with other I2C chips.StartupI2C init to 400 KHzScan all possible addresses via HAL_I2C_IsDeviceReady() loop Remember add...
Hi, in the ST BLE App, how to choose the right acquisition time in the FFT setting for ism330dhcx vibration sensor? Please advise. Thanks!
