MEMS (sensors)

Resolved! MEMS studio & STEVAL-STWIN KT1B

does MEMS studio support STEVAL-STWIN KT1B board ; cause according to the UM (https://www.st.com/resource/en/user_manual/um3233-getting-started-with-memsstudio-stmicroelectronics.pdf) only STEVAL-STWIN KT1 Hardware compatible (not with full/reduced s...

Resolved! How can i write and read on SD using FREERTOS e FATFS?

Hello,I am using STEVAL-STWINKT1B development board and I can write and read sd card using setting to SD 4 bits Wide Bus and FATFS.If I add on STM32CUBEMX as middleware FREERTOS I can't read the SD in fact I get back FR_NOT_READY when I execute the f...

How to read and write to SD the iis3dwb sensor at maximum rate?

Hi, I'm using the STEVAL-STWINKT1B development board to read the iis3dwb accellerometer and write to the sd as in the HSdatalog example.To do this I use freertos and fatfs.I created the project first on CubeMx where I set the parameters to read SPI, ...

X-CUBE-53L1A1 SimpleRangingExamples using mutex in free RTOS environement

I try to add mutex in the X-CUBE-53L1A1 SimpleRangingExamples I have defined #define VL53L1_GetI2cBus(...) CO_Mutex_get() in vl53l1_platform.c #define XNUCLEO53L1A1_GetI2cBus(...) CO_Mutex_get() inX-NUCLEO-53L1A1.cand also for PutI2cBusBut the driver...