MEMS (sensors)

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Cannot conect to STEVAL-STWINBX1

Hello, I have received the STEVAL-STWINBX1 evaluation kit and am trying different demos to see how it works. At first I was programming the board with different examples (STM32CubeFunctionPack_STBOX1_V1.5.0) but I was having problems afterwards. Once...

aag by Associate II
  • 1 replies
  • 0 kudos

How to resolve a STM32CubeProgrammer error: "Error: No STM32 target found!" while using a ST-Link/V2-lsol probe connected to a eval board via the 20->14 pin adapter?

I have a eval board connected to a ST-Link/V2-lsol using the 20->14 pin adapter. The ST-Link/V2 is connected to my linux workstation via USB and the ST-Link is seen by the STM32CubeProgrammer application. The is also c...

dmcph.1 by Associate
  • 1 replies
  • 0 kudos

Resolved! Total Reset For Sensortile not (Sensortile.Box)

Hi, i have a problem with my sensortile. The kit that i have is the STEVAL-STLKT01V1. I think i have done a mess using the SMT32CubeProgrammer and now i have a sensortile that dosen't work or connect to bluetooth. The only things that i can do is to ...

ACarl.3 by Associate II
  • 4 replies
  • 1 kudos USB connection does not work.

I am trying to work through the labs from the recent ST sensors workshop. The very first step in the Pro-mode lab is to enter the DFU mode and program the with a precompiled image. The problem is that when I connect the tile to my co...

Rita Ch. by Associate II
  • 4 replies
  • 0 kudos

STM32CubeProg failed to download FP-AI-SENSING1

Hello,STM32CubeProg outs "Error: failed to download Segment[0]" and failed to download FP-AI-SENSING1(SENSING1.hex).My envs are,SensorTile kit with small cradle.The FP-AI-SENSING1 ver.3.0.0The project is imported from SW4STM32 to STM32CubeIDE ver.1.0...

Yuk117 by Associate III
  • 1 replies
  • 0 kudos