Good afternoon! I used an example from the link https://www.st.com/en/embedded-software/fp-ai-predmnt2.html However, the card does not connect to the cloud, I have already downloaded the certificate and private key and it gives an error. ...
I use LIS2DS12 This is my init function void LIS2DS12_Init(void) { uint8_t ctrl_1 = 0x72; //0111 for 6.4kHz ODR [7:4], 00 for 2g [3:2], 1 for high frequency available[1], 0 for BDU not activated [0] uint8_t ctrl_2; // [6] for soft_reset, [1] for ...
Hello,I was having fun with the Sensortile.box Pro I bought a month ago. When I reset the device to its factory settings (SensorTile.boxPRO.bin in file en.stsw-mkboxpro-fs.zip) using the STM32CubeProgramming tool, the device blinks the red LED once a...
Hello,I have a requirement to log the data from evaluation board STEVAL-STWINBX1 to cloud. I have created Azure IOT hub and while initiating the cloud logging from the app i was unable to successfully connect to the created IOT Device created in azur...
SpoilerHello everyone,I received a STEVAL-STWINKT1B to conduct research about predictive maintenance, and right now I need to get some data into my computer through USB. I have installed FP-SNS-DATALOG1 on it. I followed the manual for the particular...
Hi everyone, I have an STM32L4 series-based board with an embedded LIS3DH sensor. I've written code to read temperature values from it, configuring all settings as per the datasheet. However, I'm having trouble obtaining the exact temperature value ...
Hello!I am trying to create a program where I send motion sensor's data via BLE using evaluation board STEVAL-STWINKT1B. For that, I have used as a guide the firmware example on the board's website (https://www.st.com/en/embedded-software/stsw-stwink...
Hi,We are trying to evaluate Sensortile.box (STEVAL-MKSBOX1V1). I downloaded the apk from the ST Website for android app and installed it.I followed the steps mentioned in UM2580. When I tried to connect the device to app. It was asking for firmware ...
I am using STM32L452RE Nucleo Board and LIS25BA module.I2C works fine. I wish to get accelerometer data through TDM now. I am unable to do so. For now, I am using polling mode. The code I am using is given below and the SAI configuration I am using i...
Hello,I am experiencing a port fault issue with my Steval-MKI109v3 board which is equipped with an LSM6DSV16x sensor. Despite following the tutorial, I cannot locate the St virtual port on my device. Additionally, I have updated my drivers based on t...