I have follow the Integration of the LSM6DSM drivers from here : https://github.com/STMicroelectronics/STMems_Linux_IIO_drivers/blob/linux-4.4.y-gh/README.md & https://github.com/STMicroelectronics/STMems_Linux_IIO_drivers/tree/linux-4.14.y-gh/driver...
Is it possible to use SAI for PDM microphones and ALSA with the current Linux kernel on a STM32MP157CAA SoC?
Hello STM,looking the the mainline kernel for the IMU line, i see some comments in the code that say the only supported ODRs are that of up to 416 Hz. is it possible to run the sensor in high performance mode with the current linux driver? Is there a...
Hi all, I am currently attempting to extended support to the lsm6ds linux driver(https://github.com/raspberrypi/linux/tree/rpi-5.10.y/drivers/iio/imu/st_lsm6dsx) which supports the ISM330DHCX. It currently supports interrupt based buffering. I'd like...
I use ASM330LHH as Linux IIO.Source and DTS were added.We found that /sys/bus/iio also added a device.I also checked reading data in direct mode from sysfs.Therefore, I think there is no problem with the H/W connection.I want to use Trigger mode to ...
Currently, we are using I2C from userspace to poll the LSM9DS1. However, this increases the CPU load on our device. This is why we would like to use the Industrial IO driver to reduce this impact.We have already patched our kernel v4.14.78 with https...
Hello,I'm try using ISM330DLC connect to Linux OS on board IMX8MP via I2CLinux supported driver for this device (iio/imu/st_lsm6dsx); I added to dts file as below:&i2c5 { clock-frequency = <100000>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl...
Posted on January 19, 2015 at 16:24I can get the STEVAL-MKI121V1 to work under Windows via the Inemo SDK. I would like to have a similar setup under linux. Is there a driver (module) and SDK available to do the same?What would be the fastest and eas...