Hi,  I am integrating nrf5340 With STEVAL-MKI197V1 Adapter PCB. We are using I2C interface to communicate. As per the LSM6DSOX datasheet, We need to pullup CS Pin for selecting I2C communication and SDO/SA0 pin status (Either connected to Pull up or ...

Hi,We are trying to evaluate Sensortile.box (STEVAL-MKSBOX1V1). I downloaded the apk from the ST Website for android app and installed it.I followed the steps mentioned in UM2580. When I tried to connect the device to app. It was asking for firmware ...

Hi, We are using SPBTLE-RF BLE module in our design. In Production, We are observing the following issues.Observation-1:After the PCB is assembled.When we do Power Check. On few PCBAs We are observing current value of 70mA to 80mA. If we isolate the ...