Ask questions and find answers on ST MEMS sensors, such as the LSM6DSV and the LSM6DSL. Learn how to use the SensorTile.Box, and STEVAL kits.
Hi everyone,I'm working on a project involving the STEVAL-MKBox Pro and would love some guidance from the community, especially since I'm still relatively new to this ecosystem.Here's what I'm trying to achieve:• Configure sensors on the STEVAL-MKBox...
Hello all,I am developing a vibration measurement device using LSM6DS3TR-C. Most of the time the data were in good shape (99%). However, I noticed some spike in my vibration intensity reading randomly. After checking the raw data I saw some step cha...
Hello,after updating MEMS Studio to version 2.3.1 I am experiencing an issue when working with FSM configurations.Previously everything was working correctly, but now I cannot reload FSM configurations saved as JSON files.Steps to reproduce the issue...
Dear Sir or Madam,I require a RoHS declaration of conformity for the following component:STEVAL-MKI208V1KCould you please share it?Thank you very much and kind regards,Thomas
In the past, I have used an LSM330 to wakeup on a gyro z-axis threshold and activate the INT1 pin as shown below:Gyro_WrByte(GYRO_CTRL_REG1, 0x3f); // 95Hz DataRate : 25Hz Cutoff : Normal Mode : Enable All AxesGyro_WrByte(GYRO_CTRL_REG2, 0x07); // HP...
After reviewing the website, we noticed that the LSM9DS1 is currently listed as obsolete. We would therefore appreciate your guidance on the following points:Is the LSM9DS1 still recommended for new designs, or should it be avoided given its obsolesc...
Hello, I have encountered some issues while developing with the ASM330LHH. During the initialization sequence of the ASM330LHH interface, I first read the WHO_AM_I register. After confirming that the value is correct, I proceed to access other regi...
I am evaluating the MotionFX library for a 9-axis orientation project. To confirm our hardware selection and production path, I have three quick questions:MCU Lock: Is the MotionFX static library (.a) restricted to STM32 microcontrollers only, or can...
Dear STMicroelectronics Support Team,I am currently working with the A3G4250D gyroscope and evaluating its temperature sensor output over I²C.According to the datasheet, the temperature sensor output change versus temperature is specified as −1 °C pe...
I'm using a LIS3MDL magnetometer on my board, and I figured out how to calibrate it to account for distortions caused by the board, and the procedure works. However, it seems that every time the same magnetometer is turned off and re-powered, the me...
