I would like to calibrate 2 magnetic sensors concurrently with MotionMC library. However, the functions from the library for MotionMC_Initialize, MotionMC_Update and MotionMC_GetCalParams do not need inputting an ID. If calibrate 2 sensors in the s...
Looking in the example code for the lsm303agr I noticed a function: /** * @brief Enables the magnetometer temperature compensation.[set] * * @PAram ctx Read / write interface definitions.(ptr) * @PAram val Change the values of comp_...
Can anyone confirm if temperature measurement is functional on the LSM303AGR? I have everything else up and working just fine with measurements over several weeks, but temperature just return 0x00 for Hi and Lo byte. This is the third generation LSM3...
Hello,I want to use the LIS3MDL for a project. I am using a microcontroller with I2C lines at 3V3. In the datasheet there is mentioned that the typical voltage for VDDIO is 1V8 but with a range up to VDD +0.1 V. I will power the device (VDD) with 3V3...
Hello everyone. I make some project based on MotionMC and MotionEC libs. It's a magnetic compass which will use inside the cars. Within the MotionMC library, the end device functions properly if calibrated according to section 2.2.5 of the UM2192 man...
I'm using an LSM303AGR to create a compass using the MotionEC library for calculating quaternions.Since the ODR of the magnetometer inside the LSM303AGR is 20Hz while the ODR of the accelerometer is 25Hz with which frequency and with which data is it...
Based on the datasheets I can not figure out the difference between the IIS2MDC and LIS2MDL. I am looking for an e-compass for navigation.
Hi, Can we use ISM303 for a Tilt-compensated compass application? When checking the 'Applications' in datasheet, 'Tilt-compensated compasses' is not mentioned in the datasheet of ISM303, but it is mentioned in the datasheet of LSM303, which are both ...
Hi, I am looking into using the LIS3MDL 3-Axis Magnetometer in an application with high frequency oscillating magnetic fields. I have looked through the datasheet of the LIS3MDL and it seems to meet most requirements that I've checked. My application...
I am using lis3mdl and try to use libiio in my programm.In my programm I enabling chanels and try to create buffer with iio_device_create_buffer function. It fails with error "Operation not permitted".Also "WARNING: High-speed mode not enabled" messa...