HiI am building an app where the transmitter has no power constrains, but the receiver needs to run at lowest power.The transmitter (master unit) will be sending pings such that any receiver (slave) near by would respond by sending its ID to the tran...
Hello everyone, I am completely new to the forum and to the world of LoRaWAN on microcontrollers.I am doing my undergraduate final project. This is based on a B-L072Z-LRWAN1 core that has a couple of sensors connected to it. One of them is an ADC sen...
I am getting the following errors when debuging the project from the package. I have the standard package downloaded directly from the official website, I've also done a full chip erease and after this, load the firmware again, and the error persists...
According to the user manual (st (dot) com/resource/en/user_manual/um2115-discovery-kit-for-lorawan-sigfox-and-lpwan-protocols-with-stm32l0-stmicroelectronics.pdf), you can optionally close SB13 to get a 32MHz clock signal to the MCU instead of attac...
How can I wake up the B-L072Z-LRWAN1 STM32L072CZ PA0 pin when I want to measure the begin and end of a movement plus gathering measurements from the FIFO after one or several FIFO watermark interrupts?Ideally I want to let the STM32 go back into low ...
Say I want the Projects/B-L072Z-LRWAN1/Applications/LoRaWAN/LoRaWAN_AT_Slave project loaded up.What exactly am I supposed to do in the IDE?I've loaded that project up, but can only build the debug configuration - it doesn't seem right.I did change th...
I've read all topics regarding this error on the forum but nothing helped. The borad connected to Arduino connector is USI® WM-SG-SM-42. Projects build succesfully and connect with the board through ST-Link v3. This is the output I get when debugger ...
