Hello!I come there after some days of work on the stop mode on the dicovery board STM32L0 with LoRaWAN.I tried to generate a new project which does nothing, to test the stop mode with RTC following the datasheet and measure the current consumption. I...
Hello,I am trying to configure NUCLEO-L073RZ board in the P-NUCLEO LRWAN2 package as the end node in the STM Cube IDE Software and for that I am using "LoRaWAN software expansion for stm32 cube IDE". I followed this directory path in the library, {en...
Hello,I am working on a point-to-point communication project using the P-Nucleo LRWAN2 board package. In this setup:The NUCLEO-L073RZ acts as the transmitter.The NUCLEO-F746ZGT6 acts as the receiver.I have downloaded the LoRaWAN package for STM32Cube...
I was using B-L072Z-LRWAN1 in a project and found out that I needed a very higher transmission rate than LoRa. I am asking if you can suggest me a board that is capable of data transfer rate of 2 Mbps with a duty cycle of 0.2ms. The data size is 30 B...
Hello, I am using B-L072Z-LRWAN1 in a project. I have one board acting as a transmitter and 3 boards acting as receivers. My question is: Is it possible to transmit and receive with a rate of 5kHz with is every 0.2ms a 30 byte payload using LoRa?
I have a P-NUCLEO-LRWAN3 and I have downloaded the I-CUBE-LRWAN expansion software.Using the project "STM32CubeExpansion_LRWAN_V2.1.0 \ Projects \ NUCLEO-L073RZ \ Applications \ LoRaWAN \ LoRaWAN_AT_Master \ STM32CubeIDE \ LRWAN_NS1" and following th...
I'm new to the ST development Environment and it is my first time to be using embedded systems. My aim is to make a project of one master that communicate with multiple slaves. I have already tried the ping pong example with 2 B-L072Z-LRWAN1 boards a...
Hello STM Community,I'm currently exploring the capabilities of the Nucleo-WL55JC1 development board and its compatibility with Amazon Sidewalk. Amazon Sidewalk is a low-bandwidth, long-distance wireless protocol designed for certain IoT devices.Coul...
I am using the p-nucelo-lrwan3 and I have been using the i-cube-wl project and i did some changes to the region and to the activation mode but it doesn't join the network can any body help me with it
Hello, I would like you to help me to communicate two microcontrollers (The B-L072Z-LRWAN1 Discovery kit LoRa/Sigfox module (Murata) using Lorawan, I was researching and looking at some libraries that were an expansion for Lorawan. But I don't know h...