VL6180X software graphical user interface (GUI) user manual
VL6180X software graphical user interface (GUI):with the TAB Options the Flash action can be performed, but I can't find any documentation.
MEMS (sensors)
Ask questions and find answers on ST MEMS sensors, such as the LSM6DSV and the LSM6DSL. Learn how to use the SensorTile.Box, and STEVAL kits.
Forum Posts
Are there ODR limitations for the ISM330DLCTR accelerometer and gyroscope when using the FIFO in continuous mode?
I am using an ISM330DLCTR IMU currently and have a FIFO running in continuous mode with an ODR of 6.66kHz. I was trying to get the accelerometer and gyroscope to both run at ODRs of 6.66kHz, but when I try this, most of the data is garbage. It seems ...
AppMEMS#3: The X-CUBE-MEMS1 expansion software package - test utilities
This software is based on the STM32CubeHAL hardware abstraction layer for the STM32 microcontroller. The package extends STM32Cube by providing a board support package (BSP) for the sensor expansion board. The drivers abstract the hardware low-level ...
State Machine and stack size ?
Dear Members,I have a state machine but it seems that it stuck in one state,Is it related with stack size ?It's stuck on "case PULSE_IDLE" no matter the value of sensor_value,The code :switch(currentPulseDetectorState) { case PULSE_IDLE: ...
LIS3MDL Magnetometer Calibration
Hi, From what I've been told, the LIS3MDL magnetometers self-calibrate upon turning on. I have taken some readings from 3 different LIS3MDL's and plotted the values in a similar way to the beginning of this tutorial: https://thecavepearlproject.org/2...
I have the STEVAL-MKI109V3 motherboard and the STEVAL-MKI190V1 (LIS2DTW12) board. I cannot find the device name in the Unico GUI 8.0.1.0 software.
I am running Windows 10 and installed the latest version of Unico GUI. The device is new. Is the software not yet supporting the device or am I missing something.
How to derive the comparison limits for LSM6DS33 self-tests?
Regarding this thread:https://community.st.com/s/question/0D50X00009XkX2bSAF/lsm6ds33-problem-with-self-test?t=1558067735502The last comment by Petr says that the self-test values such as Min(ST_X) are derived from the Full Scale range, but he doesn'...
Any success talking to a MEMs device in the socket of a MEMs expansion board?
I have a Nucleo board with an IKS01A2 expansion board. I can address the sensors on that board over i2C to read registers on the sensors, using the HAL library calls. However, I plug an STEVAL-MKI174 board into the 24 pin socket and try to address it...
what is the effect of mechanical shock and vibration on MotionFX sensor fusion library. What can go wrong if mems sensors placed on a cricket bat undergoing 30g force for few millis when ball hits the bat?
MotionFX,LSM6DSM,LSM303AGR,Sensor fusion,Mechanical Shock,Vibration
does MotionFx library work in non ST MCU?
Our existing products are using NXP MCU and IMUs. We plan to switch to ST IMUs for the next generation, but still keep the existing nxp mcu. Is this possible? Can motionFX work in different mcu (m4f)? thanks!
