Ask questions and find answers on ST MEMS sensors, such as the LSM6DSV and the LSM6DSL. Learn how to use the SensorTile.Box, and STEVAL kits.
We have integrated LSM6DSV16X (IMU) and ISM303DAC (magnetometer) on Android 10 running on the NXP i.MX8MM EVK.The magnetometer and accelerometer, gryoscope drivers are working correctly, and raw values are verified using sysfs and logcat.However, th...
I have a question regarding how the averaging filter works in the LPS28DFW pressure sensor (AVG[2:0] in CTRL_REG1).I am wondering whether:A) AVG controls internal ADC oversampling for each individual pressure measurement (i.e., multiple internal samp...
So i'm trying to install X-CUBE-MEMS1 in the IOC file of a STM32N6-DK board. The problem i can't seem to install it? All the tabs are greyed out and have little red cpu marks by them. Is X-CUBE-MEMS1 supported on STM32N6 processors? When i go to...
Hello, I am working on adding a pedometer to the Sensorwatch project using this chip.I have the step counter working well, and I also have it working with the LIS2DW. Here's a video of it :)The LIS2DW works by sending 12.5Hz worth of data from its FI...
Hi,It's mentioned in the datasheet that the sensor will convert the FIFO from streaming (reading data all the time) into FIFO (holding the data until it's read) If i am getting it right, then my question isWhen exactly will the sensor read ? Will it ...
I was asking can I sense (generate interrupt) over the overall acceleration ?Because in the datasheet it was mentioned that I can manipulate the interrupt between X, Y, Z high and low.But it'd be helpful for me if I can generate an interrupt based on...
Parts i'm looking to connect * STM32N6 - microcontroller * LSM6DSV320X - Master Sensor IMU * LIS2MDL - On sensor hub Magnetometer Question - is there any benefit to connecting the IMU master sensor to the LIS2MDL on the sensor hub vs connecting ...
I tried to connect one MP34DT01 mic to NUCLEO-N657X0Q via SAI peripheral's PDM interface. I included my project's clk configuration, peripheral configuration and main code below.Debugged and when i only touch the mic, value is changing. HELP
Hello.I am using an STM32H562VI board with an LSM6DSV16X sensor,and when I read the whoami value, it reads as 71.I configured the register as follows to check the interrupt on INT1./* Enable Block Data Update */ lsm6dsv16x_block_data_update_set(&dev_...
I'd like to validate ST1VAFE3BX vAFE measurement data against test signals as part of hardware design validation of a custom ECG sensor design based on ST1VAFE3BX. I intend to input reference signals (differential or single ended) into the two bio ch...
