Hello,I want to read which stack is updated in my controller. For example stm32wb5x_BLE_Stack_full_extended_fw / stm32wb5x_BLE_Stack_light_fw / stm32wb5x_BLE_Zigbee_RFD_static_fw. So can I read back the stack name using code? Is there any way to read...
Hi all,some time ago I successfully developed a firmware for a ZigBee sleepy end device running on a STM32WB5MMG module. I could manage the module to draw only about 3µA in low power mode while still being able to communicate a button press over the ...
I have two STM32WB5MM- DK . Using an example for a diffrent board I have configured one of them as router and other as server. I dont know if they are getting connected. I need to connect these exclusively and then connect the router to Mobile phone...
Hello everyone, I want to measure the current consumption in low power modes on a STM32WB5MMDK discovery board, I would have two questions 1) I have clock issues when I want to use MSI clock to have a 2MHz SysClk to put my STM32 board in Low run pow...
Hi everyone, I am facing a real issue with stm32WB30. I try to connect my board to the ST BLE toolbox and I use a video on YouTube that was created by ST as a main example of how to program and run BLE ( link of the video: https://youtu.be/i10X4Blr8n...
I want to add a new timmer application in the "BLE_MeshLightingPRFNode", so I need to know which timmer is available.Because the RTOS needs a reference timer, but I don't see the RTOS initialize and activate sequence in this sample code. Is RTOS not ...
(1)I am trying to develop a product using the STM32WB5MMG.Can I leave the unused IO pins of the STM32WB5MMG as NC?Do I need to do pull-down (or pull-up) in HW?The STM32WB5MMG has a lot of IO pins.If I need to place a pull-down resistor, I'll have to ...
Hello everyone, I want to measure the current consumption on a STM32WB5MMDK discovery board. I've found that I had to put an ammetre on the jumper JP1, and I programmed the RGB LED to be working. However, when I put the ammetre and I power my board, ...
I am trying to set the maximum number of times I send out an advertisement, I managed to do it with the extended advertisement quite easily. I did this using the "adv_set_param[i].adv_set.Max_Extended_Advertising_Events = 8;"However now I want to do ...
Hello everyone,For my application, I need to record a time counter in flash memory, with a resolution of 1/10 of hour (eg. 6 minutes).Here is what I do :As I know there is a limitation for flash lifetime (10000 erase cycles), I built an algorithm whi...