Ask questions and find answers on ST MEMS sensors, such as the LSM6DSV and the LSM6DSL. Learn how to use the SensorTile.Box, and STEVAL kits.
Posted on January 28, 2018 at 17:21Hello everyone,I apologize if my question is too basic for this forum but i've been reading so many sources in the internet and i am still confused and I am pretty much new in this subject.I want to hear ultrasound...
Posted on March 13, 2018 at 09:25Good morning,I'm looking for more information about the LSM6DS3 sensor.Indeed, I want to record the activity of a mouse so I would like to put an accelerometer+gyroscope on the mouse to see its velocity and position....
Posted on March 09, 2018 at 07:12The register configuration is as below array which corresponds to ctrl_reg 1-5 of LIS3DH. I read back the ctrl_reg after configure it, the result is correct which means the register is programmed to the value as I wa...
Posted on February 21, 2018 at 02:36Simultaneous Wake-Up/6D EventsI have a similar problem to https://community.st.com/thread/42585-lis2ds12-does-wake-up-interrupt-block-other-interruptsreported by https://community.st.com/people/ben.005.I want an L...
Posted on March 12, 2018 at 14:48Hi, Thank you for reading my question. I always get the same values of x,y and z for using FIFO mode on LIS2DH12. The x, y and z values will change for each interrupt of WTM, but the three values are the same. M...
Posted on March 09, 2018 at 09:34LSM330 device register is 7bits, but SPI interface express address 6 bits AD5...AD0Please tell me how to access register higher than 0x40.
Posted on March 07, 2018 at 09:33HiI�m working on a projekt where I have to measure the acceleration relative to the gravitation. I want to get an alert when there is an relative acceleration in any direction greater than x mg. I have tried with the...
Posted on March 07, 2018 at 13:10Hello People,I am trying to get data over i2c from LIS2DE12 sensor. Here I am attaching a screenshot so you can see the way I am configuring its register to read data for x,y and z axis. I dont want to use any inter...
Posted on March 08, 2018 at 11:40Hi,I'm trying to use the LSM6DS33 as an inertial navigation aid, participating in sensor fusion. The problem is that the application has large amount of vibrations and the accelerometer data is quite noisy. I need ar...
Posted on March 09, 2018 at 21:37Hello,I am trying to get both Interrupts 1 and 2 to trigger for two different movements and at different intervals of the time . But somehow only interrupt 2 is getting generated. Interrupt 1 is not getting called at...
