STM32CubeIDE (MCUs)

cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

failed to start GDB server error

hello forum,I am getting following error - see picture https://i.imgyukle.com/2020/09/07/xXWynv.pngI use blue pill f103c8 - voltages are ok - blue pill is alive I can see the LED blinkoriginal st link v2 LED is red - driver is ok no error in device m...

HardFault Debug in STM32CubeIDE

Some time ago, I was getting a Hardfault in a STM32F103 baremetal firmware. Even posted the question here, but I wasnt able to fix it. So, I moved to FreeRTOS-CMSIS, not to get rid of the problem, I was moving anyway. I'm still with this issue.I thin...

0690X00000BuhwiQAB.png
rrnicolay by Associate II
  • 3019 Views
  • 11 replies
  • 0 kudos

NUCLEO-F103RB: No device found on target.

Hello,For the past two days I have started experimenting with STM32F0 and STM32F1 Nucleo Boards and the STM32CubeIDE, so I am not that experienced yet. Everything went fine but suddenly, I was not able anymore to program my NUCLEO-F103RB board. It th...

WBach by Associate II
  • 315 Views
  • 1 replies
  • 0 kudos

DEV_TARGET_RESET_ERR

It is an STM32F103C8T6 chip, and I am trying to connect it using st-link v3.Connects to SWD,(Connected VCC, SWCLK, GND, SWDIO 4pin)In STM32CubeProgrammer, it is connected normally and both read/write are possible.However, it does not work when debugg...