STM32CubeIDE (MCUs)

cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! How can I calculate an approximate IWDG window ?

Development Board: Nucleo-L476RG.IDE version: STM Cube IDE 1.11.0For the system watchdog timer, there's an equation(attached.) Is there an equivalent equation for the IWDG ?Any suggestions would be appreciated.Thanks

mm.51 by Associate
  • 546 Views
  • 1 replies
  • 1 kudos

IWDG is not stopped at breakpoint - worked w/o change before

With a one-task-program (no RTC) on a STM32L476 and Cube-IDE rev. 1.7.0:Until yesterday the IWDG was stopped at breakpoints and I could debug line by line, because the watchdog paused.Since today the iwdg is not stopped and restarts the porgram after...

pl by Associate II
  • 576 Views
  • 3 replies
  • 0 kudos

Reset when adding or removing breakpoints

I have a STM32L072 and when last I worked on the project, from what I rmember, there were no debugging issues at all.When I started to work at it again now, I see this effect that, when, in STM32CubeIDE, using a STLINK V3SET debugger, I am in a debug...

SKled.1 by Senior II
  • 419 Views
  • 8 replies
  • 0 kudos