PART# STM32H747I-DISCO (Mouser S/O 935751) We have a customer tried the demo program on ST website, ./en.STM32H747I-DISCO_demo/STM32H747I-DISCO_demo"Three example programs based on TouchGFX�?STemWin�?EmbeddedWizard, open a random folder, use STM32Cu...
When I flash some .bin the LCD doesen't work. It just display the a noise picture. With similar examples does work and with more advanced examples like the EmbeddedWizard it works too.When does not work, every time display the same static image:
Posted on August 17, 2017 at 18:07Hello all,I'm using the STM32F429 Discovery Kit and running the LTDC in 8 BPP (L8) mode. I have STemWin and am displaying their colour bar sample. I have a problem with colour conversion where the colour bars appear...
Hello!I bought a new STM32F469 discovery kit and wanted to test it. since there was no initial program installed (checked by connecting with the USB port) I tried to launch one of the demonstrations from the firmware package over STMCubeIDE (Vers. 1....
I am working on a gui using an STM32H747I-DISCO connected to an external 640x480 display. The external display does not have a DSI interface, so the DSI-related code in TouchGFX is commented out.The display works perfectly for static images, but heav...
Hi Guys,So this is with a TouchGfx Cube v6.7.0 generated project with FW 1.11.0I have added OpenAmp via Cube and based the code I am adding on the old PingPong example.The following line fails with -2005 (RPMSG_ERR_BUFF_SIZE):int32_t status = OPENAMP...
Normally, it's possible to activate LibJPEG in CubeMX to enable software decoding for MJEPG videos in TouchGFX. Is this also possible for STM32U5 (I'm using the STM32U5A9J-DK), as this option doesn't seem to be available in CubeMX?
I created a project in TouchGFX Designer and then I opened the project in CubeMX. It compiles successfully. But then I want to add UART function to my project. So I go to CubeMX and add UART function but when compiling it gives an error because the s...
Hi everyone,I have some misunderstanding about the use of the DBANK bit of the configuration bits.I have a costomized SPI bootloader located at address 0x0800 0000 and an Application starting at 0x08005000. So both are located on the Bank1. I made th...