I am trying to integrate STM32CubeMX and TouchGFX using IAR EW on STM32F769I-Discovery Board. I followed the instructions on the link below to configure the board:https://touchgfx.zendesk.com/hc/en-us/articles/360020208091 Then, I use ST-link Utility...
I have been trying to program the mentioned display. Whilst using TGFX 4.20.0 I can program an empty project then, generate code and upload from CubeIDE 1.9.0 without issue. Adding an image to the empty project and run target from TGFX works no probl...
Hello everyone, I've got custom-made board with STM32F407VE and W25Q16 SPI flash with TFT Display installed.So I've decided to develop my own external loader for SPI flash for storing images in my TouchGFX project. I've managed to read data from flas...
Use touchgfx example with stm32f429 discovery Keil with st link usbWhen I download it with 2 wire (swd), I get the message cannot load flash programming algorithm. Is there a solution?(It is the same even if you change the debug option 0x10000000 or ...
Hi Guys,So with TouchGFX we can end up with lots of graphics data that resides in external flash.ST-LINK_gdbserver I think uses the ST Programmer to flash the elf which flashes the normal flash and the external flash.If there is a lot of data then th...
I am experimenting with a newly purchased STM32F469I-DISCO AU.I immediately had issues in downloading to the external flash. Is not a configuration issue, in fact the error is random: 5% of the times I manage to correctly flash it, most of the times ...
Hello, in the past two days I've been trying to get working STM32L053R8T6 on my board. I managed to isolate the error down to one setting in LCD module. When using static duty the MX_LCD_Init() init function passes and program executes like usual. Bu...
STMicroelectronics ST-LINK GDB server. Version 5.9.1Copyright (c) 2021, STMicroelectronics. All rights reserved.Starting server with the following options: Persistent Mode : Disabled Logging Level : 1 Listen Port Number : 6123...
I am running FreeRTOS on an STM32H745I board in a TouchGFX application. All tasks I want to run are on the M7 core. I'm trying to periodically send data over UART3 to the virtual COM Port of the STLink. The HAL returns an ok status when transmitting,...
Hi everyone,I’m working on a custom display board with a STM32H7A3 MCU and a MX66LM1G45G 128Mb OSPI flash. I have build a custom external loader following ST tutorial, with H7 params. I use JTAG to flash.When it comes to use my .stldr custom loader i...