Ask questions and find answers on ST MEMS sensors, such as the LSM6DSV and the LSM6DSL. Learn how to use the SensorTile.Box, and STEVAL kits.
Greetings! I am using the LIS2MDL magnetometer in continuous mode (10 Hz) with hard-iron offset and interrupts enabled. (Full settings: CFG_A: 0x90; B: 0x0A; C: 0x50; INT_C: 0xE5) And I am trying to detect a magnetic object coming near the device. Th...
Hello community ,I am going to do 9 axis sensor fusion (6axis accel and gyro + 3axis magnetometer) and got across to the MEMs-Studio suite. I've bought STEVAL-MKI109D for motherboard and STEVAL-MKI217V1 as the shield. STEVAL-MKI109V3 is out of stock ...
Hi.I'm working with the FSM in LSM6DSO. I'm able to program detection which I want, but I struggle to do something like "fail-safe" to avoid the algorithm to stuck in the middle of the detection.For example, I want to do a "throw" detection of a thin...
Hello,I'm trying to write to configuration register of P3T1750 sensor, I can perform this with I2C protocol but it not successfully with I3C, the sensor still ACK the write command but it NACK the read command to configuration register. With the temp...
Hello, I am trying to use a proteus1 to monitor temp and vibration on a spindle and i just cant seem to find the best way to do this. I would like to use a cloud so I can monitor it off site and get a notification if the temp rises above a threshol...
Hi everyone,I am struggling to get MotionFX (9-axis sensor fusion) working on an STM32L476G-DISCOVERY board using the onboard LSM303C (Acc/Mag) and L3GD20 (Gyro).The Problem: Despite the library being initialized and updated in the main loop, all out...
Hello,I have two technical questions regarding the lis3dh accelerometer behavior and interrupt configuration.1) Are the values I read from the LIS3dh in m/s²???? Exemple :::Accel [LIS3dh] 28807220458ns (-7.300384, -1.942303, -5.712095)2) Interrupt ...
Hi,I am using IIS2ICLX MEMS accelerometer in an IOT device.The IIS2ICLX is soldered on a PCB that sends data to internet every 10min.To measure the zero-g level of both x and y axis, I suspend the device from the ceiling so that the PCB (and the acce...
Hi. I have been looking at the internal operation of MEMS devices and am looking for information on how this sensor takes the reading from the mechanical parts. I am trying to find out if this sensor uses capacitive sensing or frequency drift and tim...
Hello everyone. I would really appreciate if someone could help me sort out a really annoying issue i have with a new STM32WB5MMGH6 based board i made.On this board i have two sensors connected to the same SPI interface (hspi2) with different CS pins...
