Hello everyone,i want to config gpio pin as adc chanels on stm32f103c8t6, i have read the GPIO chapter and ADC chapter,but i can not find out what is GPIO pin for each ADC chanel,example GPIOA_pin0 for ADC1_chanel0...,what is the chapter describe abo...
Hello, I'm building a project where I will use CAN, UART and a TIMER. All of these work with an interrupt. How it works: I get data via CAN and use a TIMER to send a Request on the CANbus. With the UART I need to receive some commands that will trigg...
In the ADC scan mode in STM32 microcontrollers, the digitized value of all input channels is dumped into ADCx->DR. Is there a register or flags to find out which ADC channel the data currently in the ADCx->DR register```void HAL_ADC_ConvCpltCallback(...
Hi,while interfacing pc8574t with stm 32 i2c communication after generating start condition and sending slave address (0x4e) as in datasheet acknowledge failure flag was enable this was the waveform i got and still can't find what could be reason i...
I'm new to CAN protocol, even though have theoretical knowledge of CAN and J1939. Still not able to implement it using STM32F103. MCU - STM32F103C8T6Transceiver - SN65HVD230CAN - J1939 I want to receive Raw CAN data from truck, store it to buffer and...
Hi,I want to program the STM32F103 with JTAG but without the IAR system.is there a tool for that?BRShmuel
Hi ,I'm working on a code to collect data from a load cell wit HX711 cip. I'm using STM32CubeIDE.I configured GPIO pin 6 as Clock output for the HX711 but when calling HAL_GPIO_WritePin the output pin PA6 does not change.The hardware configuration is...
Trying to use CubePrgrammer thru an ST-Link V2 to program an STM32F103C8T6 board and get the error "890 : ST-LINK error (DEV_NO_STLINK)". Using Windows 10. Device Manager shows "STM32STLink" under Universal Serial Bus devices. Tried removing CubeProg...
I'm trying to get the connect working from within STM32Cubeprogrammer through a stlink V2 to a STM32F103C8T6.After many, many attempts this still does not work. I keep getting: No STM32 target found. If you....etc.Granted, the ST-LINK V2 device is a ...
Hello,we are evaluating an energy efficient MCU that owns ethernet and I2S ports. We cannot find a proper evaluation board for STM32F107. The EVK STM3210C-EVAL is obsolet.Is there any available evaluation board for this MCU? Is this MCU not recommend...