Hi,I followed this tutorial to have made FatFs library work on my STM32 F411 PCB board with SPI interface.Basically I need to store 1000+ floating point values in SD card and read them back.I have no problem in writing; but I cannot read all the reco...
Hello everyone. What do you use as wifi module or ic in your pcb circuits, including stm32 processors. I don't like working with AT commands. I would like to work with SPI or SDIO interface if possible. Can you suggest a solution with libraries and s...
How I understand from this schematics: PC8 and PD2 have pull-up resistors connected to them while the rest of them don't, this means that the rest should get Pull-up resistor in the settings of the GPIO and this will enable the pull-up resistor from ...
