Schematic 1. Most documents refer to add a PU on UART TX (target side), why is there a PU on UART RX and not TX, but there is a PU on VUART TX and not on VUART RX ? Seems inconsistent.2. For consistency or guideline, should the UART PU be on the boa...
I downloaded the boot code generated by following the settings in Figure 3 (the frequency configuration to 600Mhz) into the flash of the 0x08000000 starting address, and then the stlink cannot detect after re-powering (as shown in Figure 1). But my ...
I recently started getting the following error when trying to program my nucleo-32 L432KC board: Error in final launch sequence: Failed to execute MI command: target remote localhost:61234 Error message from debugger back end: localhost:61234: Co...
Hi,I recently got a STLINK V3 SET and wondered if I could get some help setting it up to work with a board similar to the SMARTAG1. (I created a custom PCB with a very similar layout)I was trying to follow this post: https://community.st.com/t5/stm32...
Once I connect st-link v2-1 to STM32G473VBT6, there is a disk added into my PC, and there are 2 files in the disk. One is DETAILS.TXT(Version: V2J37M26 Build: May 13 2020 17:07:43), another is FAIL.TXT (The interface firmware FAILED to reset/halt t...
Hello everyone, I have had problems flashing a STM32F405 from a 3D printer board, I have not managed to flash via DFU and with a STLink-V2. Here is what I have done. - First, the board has a HID bootloader, which by connecting jumpers between BOOT0-3...
Hello, I have been using the same cubeIDE debugger options for several months and have not had any major issues. However i recently updated to the latest macOS 15.0 release (not necessarily the cause, but it's the only change that comes to mind) and ...
I didn't own a V3 programming device and found the $11 device did have a USB C type connector but would not supply power to the target so I purchased the STLINK-V3PWR device. When it arrive I could not find any of the shipped cables that would connec...
So a bit off-topic, but arose in the context of STM32 Nucleo boards:https://community.st.com/t5/stm32-mcus-products/communication-between-nucleo-f411re-and-raspberry-pi-using-st/m-p/721571 "Virtual COM Port" is a Windows-centric term - referring to t...
Currently I tried STM32Programmer_CLI and ST-LINK_CLI, both more than 100 times slower than StmStudio - StLink - SWD - MCU. The solution can only work up to 4Hz with 1 mcu and less with >1 mcu. StmStudio can run at least 250Hz with more exchanged dat...