I have been looking for a working project external loader in Keil or CubeIDEfor some of the discovery boards I haveThe only projects I see are in EWARMhttps://github.com/STMicroelectronics/stm32-external-loader I do not know why STM did this only in ...
I am trying to communicate(Tx and Rx) with the arduino serial monitor using USART2 using ppins PA2 and PA3 respectively. This si done with the assumption that these are the pins which are connected to the USB serial wires. Mt USART Tx fucntion is wor...
Hello Everyone, For a project, I'm using a NUCLEO-L432KC board and it is connected to external sensors, Tx, and Rx (which work with 4-5 V). I want to use an X-Nucleo-LPM01A to measure its power consumption. Based on the NUCLEO-L432KC documents, I hav...
hello everyone/anyone hope you are doing ok I have to make a project on stm32 nucleo l432kc I am new to this environment and finding it hard to find the relevant libraries for altium for nucleo l432kc board i need to design a pcb can anyone please he...
I'm using a NUCLEO-L476RG with the SDMMC peripheral to interface with a microSD card. I've gotten to the point where I can read and write sectors and all, but I'm getting pretty unreliable behavior on the data bus where the SD card seems to not be ab...
Im testing the power consumption in my Nucleo-l412kb board while running and stop2 mode.I found huge discrepancies when I measure current in the IDD pins, powered from the USB host, respect to powering the board with an external power supply and meas...
Hi there,I'm facing some problems on the Nucleo - L496ZG board.After switching from ST-Link to J-Link, the SWV is disabled, as shown in the image below.How to see the live data? Kindly share your ideas on this.Thanks!
Hi Team,I'm using Nucleo - L496ZG board in our project.Whenever I connect the USB cable to the CN1 connector, the ST-Link isn't detected.I have checked the ports on Device Manager and it shows Jlink instead of ST-Link.I am attaching the image for you...
Hi everyone,I'm working with the STEVAL-STWINKT1B and have a question about powering it with a 3.7V battery. The board uses the STBC02 PMIC, which operates between 4.5V and 5.4V according to its datasheet.The datasheet suggests the STBC02 charges a b...
Hi everyone,Building a predictive maintenance device with a MEMS accelerometer. Using STEVAL-STWINKT1B as reference, but missing Altium design files. Anyone have them to share?Thanks!