I am using STMCubeIDE v1.7 on MacOS 10.15.7 and connecting to my target via an STLINK V3. I updated CubeIDE to v1.7 and it suggested an update to the STLINK. Since doing that update I am not able to connect to my target (STM32F405). Errors given a...
Dear all,Could not verify ST device!This error popped up suddenly and blocks any progress. I took an older computer and had the same error again.Therefore, I suspected a hardware failure and ordered new adapters and processor boards, but I kept havin...
I am currently working on a bootloader using the NUCLEO-F446RE development board, which consists of a program that erases sectors 3-7 of the MCU's flash memory to create space for a program. When run my bootloader's erase function and then attempt t...
When I hit Debug. System stops at first line of main() as intended. However no matter how I setup any breakpoints on the rest code, and hit Resume(F8) button. The code never stops on those breakpoint. even though I am 100% sure those breakpointed li...
HI!I'm working on a design where I need to minimize the number of pins given space problems. I plan to use an ST-LINK/V3 SET without the expansion board, so I'll use just the MB1441 one.I can't find the official MB1441 board schematic to discover thi...
Here is a sequence of screen captures demonstrating the problem I'm encountering (in particular, the firmware version displayed by the software appears to become same as the firmware version intended for upgrade; the upgrade says it failed, but then ...
I want to pair the STM32 BL475E IoT01A to a HC05 module connected to another STM32F401ccu6 to send data to the IoT board.But when I tried to do so,I'm not able to find the pairing key anywhere.I tried 0000,1234,1111 but that didnt work.Is there any o...
Since the most current and the previous version of STM32CubeIDE (or maybe related to a windows 10 update) I have to start the debug session 2 times. The first time the error below is produced. If I however start it a second time, everything works. Th...
I am using STM32CubeIDE with ST-LINK V3 and Segger JTAG, and this just works.My company has now invested in a Lauterbach LA-3204, but it is not directly supported in the 'debug-settings' of CubeIDE, as ST-Link and Segger JTAG's are.I have found out, ...
I'm having an issue using STM32CubeIDE to program my blue pill boards. I get the below error each time. Error in final launch sequence:Error in initializing ST-LINK device.Reason: (18) Could not verify ST device! Abort connection.Error in initializ...
