I have an STM32H7B31-EVAL board setup with TouchGFX. I am able to compile and load a project using STM32CubeIDE. I would like to be able to do the same from the command line. I found this document that gives a very basic outline of the STM32_Progr...
Hi,I am currently working with the documentation of TCPP01-M12. I have find some small mistake in the table of recommended capacitor C3. The part codes are switched. Also it seems that the GRM188... 0603 package capacitor is obsolete nowadays. Could ...
Schematic 1. Most documents refer to add a PU on UART TX (target side), why is there a PU on UART RX and not TX, but there is a PU on VUART TX and not on VUART RX ? Seems inconsistent.2. For consistency or guideline, should the UART PU be on the boa...
Hello,UM2407 is the user manual of the STM32H723ZG Nucleo-144 development board. Likewise, the schematics of this board are available as https://www.st.com/resource/en/schematic_pack/mb1364-h723zg-e01_schematic.pdf.In both the manual and the schemati...
So a bit off-topic, but arose in the context of STM32 Nucleo boards:https://community.st.com/t5/stm32-mcus-products/communication-between-nucleo-f411re-and-raspberry-pi-using-st/m-p/721571 "Virtual COM Port" is a Windows-centric term - referring to t...
eg, UM2179 STM32 Nucleo-144 boards (MB1312):Related:https://community.st.com/t5/stm32-mcus-products/printf-causes-terminal-to-stay-just-empty/m-p/644954/highlight/true#M236811@SofLit
I'm using a STM32F469i- discovery board for developing a prototype & would like to use the Audio DAC feature in it and it is given in the datasheet that one set of pins (15 & 16 in CN12). I checked this discovery board's and also the controller's dat...
Hello,I have a new STEVAL-IDP004V2, and I recently downloaded both the ST-LINK Utility and the STM32CubeProgrammer. I'm going through AN5041 Rev 5, page 22 steps which mention the board is to be programmed with the ST-LINK Utility. I started trying ...
I have a STLINK-V3SET and I'm trying to comunicate with a STM32F103C8T6 (Blue Pill). I'm sucessful only when the board is externally powered by it's USB port. The STLINK-V3SET SWD or JTAG connectors have a T_VCC pin, which I now realized are an input...
Hi,I am working with B-U585-IOT02A.In all example project using NetXDuo stack tcp/ip (web server, Azure Iot Hub, ecc. ecc.) the communication with wifi mxchip is performed by SPI using IPC -HCI command protocol.I haven't found documentation about com...