Hello everyone, sorry if this is too easy of a task but I am quite frustrated. Can anyone help? I want to use CP2102 USB to UART bridge to send data from my PC to my Nucleo, then send the exact same data from my Nucleo to the PC so I know that the da...
Hello, Where can I find hardware configuration for BLE examples in case of development and production? Particular for STM32WB BLE-HID.
I need step by step guidelines to make my custom board for my projectsDifferent chips need different capacitors crystal oscillators and some defile connectionsi need to know that can you please guide me for thatIf you give me the full tutorial, that ...
I am just getting started with learning about motor controland identified one motor driver development board X-NUCLEO-IHM07M1im wondering if this is compatible with the STM32F411E-DISCO development boardor do i need to buy a dedicated development boa...
HI STM32 Team, I am currently working in a ethernet based project on STM32-F439ZI Microcontroller and I am looking to transmit 100Mbps which mean 12.5 Mega-Bytes per sec. But practically I can't achieve that speed I was able to achieve 8.2MB per sec...
Hello everyone, i am currently working on STM32 NUCLEO-L073RZ Projects with Ardunio Ide. I did not change anything from yesterday only i install mbed studio and after installation i delete. I did not do anything with mbed just installation, and i to...
Hello people.I just worked on a audio processing project with am STM32F407 discovery board. And everything went fine.But now I'm looking to work with a board that allows to connect a usb webcam and stream it to 2 monitors through HDMI (I assume this ...
Hi,I am currently working on EMAC and I am a beginner ,So I want to know that why RX_ER is made optional for connection and if it made optional then how the errors are detected during reception.@STea@LCE
There is an onaboard st-link programmer/debugger on my stm32 Nucleo-F446ZE development board.I want to know can I use this st-link to flash my LoRa E5 Mini board which does not have any onboard programmer/debugger facility.If yes kindly provide me co...
Hi, I need to modify this schematic, I want to use one USB connection connected to an STM32. - When the STM32 is on Bootloader mode, A virtual com port will be open and I should have an option to save a mp3 file inside the external flash (GD25P32)- W...
