About ajith1

ajith1 · 2024-11-21

Hi STM32 Team,I am working on implementing a USB Mass Storage Class (MSC) application on the Nucleo-F439ZI development board. My objective is to use the Fat Fs file system to read/write data from/to a USB flash drive.I need example code for that. Fo...

ajith1 · 2024-11-15

Hi STM32 Team,I am working with the STM32F7508-DK development board and interfacing it with an SD card using the SDMMC peripheral. The 1-bit data transfer mode works flawlessly, but when switching to 4-bit mode, the interface fails to operate as exp...

ajith1 · 2024-05-18

HI STM32 Team, I am currently working in a ethernet based project on STM32-F439ZI Microcontroller and I am looking to transmit 100Mbps which mean 12.5 Mega-Bytes per sec. But practically I can't achieve that speed I was able to achieve 8.2MB per sec...

ajith1 · 2024-04-25

Hi ST Microcontrollers Team, We are looking to Transmit/Receive UDP data over Ethernet on board NUCLEO-H745ZI-Q NUH745ZIQ$AT1.I have found a LWIP example stack for ping the device from the below git hub link,https://github.com/stm32-hotspot/STM32H7-...

ajith1 · 2023-09-19

HI STM32 Team,What is the boot process of STM32MP157A-DK1 BOARD and where to study that. Thanks in advance,Regards,A. Ajith Kumar

ajith1 · 2024-05-23

What is the maximum efficiency of Ethernet that we can achieve in practical.

ajith1 · 2024-05-23

Hi Andrew Neil, Thanks for responses,"How did you measure that, and in what network setup?"I have transmitted 5450 packets per sec(I cannot able to send more than that per sec). Each packets consists of data length of 1471 Bytes and the total packet...

ajith1 · 2024-05-23

Hi BR, Thanks for response,"I have another doubt, There is any difference between integrated phy and mac microcontroller and only integrated mac and external mac. Which I means transmission speed varies because of this architecture changes?"Sorry fo...

ajith1 · 2024-04-25

Kindly share me the project in c program project. If its possible.

ajith1 · 2023-09-26

Hi STM32 Team,I have learn about the boot process. I have understand something but I have still confusion about this. I will tell below what I understand ,Please correct me if I am wrong.1. After the microcontroller startup (or) reset.2. The boot cod...

User statistics

User Activity

USB MSC Implementation on Nucleo-F439ZI with FatFs Support

STM32F7508-DK: SD Card Interface Working in 1-Bit Mode, Fails in 4-Bit Mode

NUCLEO-F439ZI BOARD - MAXIMUM ETHERNET DATA TRANSMIT SPEED

UDP DATA SEND/RECEIVE CODE FOR NUCLEO-H745ZI-Q NUH745ZIQ$AT1

BOOT PROCESS - STM32MP157A-DK1

Re: NUCLEO-F439ZI BOARD - MAXIMUM ETHERNET DATA TRANSMIT SPEED

Re: NUCLEO-F439ZI BOARD - MAXIMUM ETHERNET DATA TRANSMIT SPEED

Re: NUCLEO-F439ZI BOARD - MAXIMUM ETHERNET DATA TRANSMIT SPEED

Re: UDP DATA SEND/RECEIVE CODE FOR NUCLEO-H745ZI-Q NUH745ZIQ$AT1

Re: BOOT PROCESS - STM32MP157A-DK1