About mm.51

mm.51 · 2024-04-19

I'm looking into creating a splashscreen and handling the uart responses. How can I wait for the input without consistently sending the response messaging. I'm unsure how to handle responses from the uart receive line. enum splashscreen_response_typ...

mm.51 · 2023-12-08

Looking into the available flash space on the chip:For the 1Mbyte variant of the device the total number of bytes should be 1,024,000. 2,000 bytes * 512page = 1,024,000 bytes of flash memory.End of Address Space - Start of address space = Amount of...

mm.51 · 2023-01-05

Development Board: Nucleo-L476RG.IDE version: STM Cube IDE 1.11.0For the system watchdog timer, there's an equation(attached.) Is there an equivalent equation for the IWDG ?Any suggestions would be appreciated.Thanks

mm.51 · 2023-01-04

Development Board: Nucleo-L476RG.IDE version: STM Cube IDE 1.11.0I have implemented this "Configuring the IWDG when the window option is disabled When the window option it is not used, the IWDG can be configured as follows: 1. Enable the IWDG by writ...

mm.51 · 2024-04-19

What do you mean by NO-OP ? So are you saying I should accept no response as incorrect ? What would you recommend doing ?

User statistics

User Activity

Handling UART receive

Flash Space calculations STM32L496RGT6

How can I calculate an approximate IWDG window ?

How can you validate that Independent WatchDog (IWDG) is resetting the processor ?

Re: Handling UART receive