I use STM32H750B-DK to do external loader function. "H750_External_Loader.zip" is my test code.On below have error happen, I got error while memcmp That's the code that I've used as my base: https://github.com/WellinZHANG/External_LoaderQSPI Settin...
I am using custom designed board having STM32H745BIT6 and 25MHz external crystal with LDO and SMPS pins connected as seen in attached snippet.I have created, compiled new STM32 project using CubeIDE and CubeMX software for LED blinking.Attached .IOC ...
I would like to use the otg_fs_vbus interface of the STM32F7508 Discovery to plug in a USB stick. When I activate VBUS in CubeMX, the board no longer boots up. The reason for this is that pin PA9 is used for the ST link (UART1) and the vbus. Both at ...
Hello-We are working with two different boards for the STM32L062, schematics of which I have attached. The first is a bare-bones development board for general testing and the second is our product. I have a Cube32MX project that enables the feature...
Hi all.I am having trouble programming an STM32G030F6P6 IC.I get multiple errors. The controller is being used in standalone mode with no external components. The Errors I'm getting are mentioned:Target no device foundError halting the deviceSTM32_co...
Hello all, I am starting a new project based on the STM32F302 MCU and I am running into an interesting clock configuration timeout issue that results in a fault during most debug sessions. So far, all I have done is configure the clock tree and enabl...
Hey Guys,So I have this Board and I have a couple of questions:1 - Last week I wanted to connect a sensor to the board, to learn some communication protocol stuff. I noticed that the board PINs (in green) are too close to each other, so, the usual RP...
Very new to ST and struggling to understand the basics. As posted in previous posts i am using the STSPIN3201 motor controller, i am trying to write the basic LED toggling program. From STSPIN32F0 data sheet i found the micro used is STM32F031C6. I c...
I'm running into an issue while designing a relatively simple custom board with an L031K6T7, where after programming it the current draw exceeds 200mA and eventually breaks to the current limit of the power supply at 800mA.When I assemble the board t...
We have a project where, due to various issues found during development, I've modified the PCB layout and changed a few pin allocations.Is there any way to include multiple configurations from CubeMX and select between these at compile time?This woul...