About SRauf

SRauf · 2022-06-10

Hi all.I am having trouble programming an STM32G030F6P6 IC.I get multiple errors. The controller is being used in standalone mode with no external components. The Errors I'm getting are mentioned:Target no device foundError halting the deviceSTM32_co...

SRauf · 2022-05-16

Hi all.I am having some trouble with communicating with an STM32G030F6 IC. I am using STM32CubeIDE to code and STlink-v3 mini to upload the code. The SWCLK and SWDIO pins are being used to upload the code. 3.3V is being supplied from elsewhere and th...

SRauf · 2022-06-21

Sorry for the late reply, I was on another project and could not test it earlier. I tried that today and shortened the wires, but it didn't work either. The code is being uploaded to one board so I can say that the wire length isn't an issue, but now...

SRauf · 2022-06-13

Tried, it also didn't work.

SRauf · 2022-06-10

AFAIK stlink v3 mini only has a 5V output pin. The input range of the controller is between 2.4 to 3.6V.

SRauf · 2022-06-10

Oh right forgot to mention, There are 100nF and a 4.7uF capacitor placed at about 1mm from the power pins of the controller. The NRST pin also has a 100nF cap. Other than that, the IR LED has a 100Ω resistor and the I2C is pulled up using 10k resisto...

User statistics

User Activity

Problem with STM32G030F6P6

Uploading code to STM32G030F6 IC

Re: Problem with STM32G030F6P6

Re: Problem with STM32G030F6P6

Re: Problem with STM32G030F6P6

Re: Problem with STM32G030F6P6