Dear all, The X-CUBE-MATTER Expansion Package is now available on our official website following this link MATTER - Matter software expansion for STM32Cube - STMicroelectronics It is a reference implementation for the demonstration of Matter on ST...
Please go and visit our wiki pages where you can find a lot of information on our wireless product families (WB, WBA, WL) and the supported protocols: BLE, Zigbee, Thread, Matter, Lora, ... To begin your technical journey, please start from this top ...
Hello,I have combine mouse with keyboard HID_12 and keyboard with media HID_23,but not able to combine mouse with media and all 3 together! Any help with resolving the problem will be greatly appreciated!Here are my HID_12 and HID_23:HID_12 0x05, 0...
We are working on a product on the STM32WB55 that is hard faulting when trying to modify AES2 peripheral registers while actively bonded to a Windows PC over BLE.What we discovered is that we can use AES2 to encrypt and decrypt just fine, but the mom...
Hello. I have very simple question: how create from blank (new project and next) in CubeIDE for SMT32WB55 (Nucleo) for BLE Mesh project (say, PRFNode analog from yours ready projects)? I don't found any description or algorithm for that not in AN5292...
I have a very generic question ,What happens if in an example for a different board . I just remove the BSP and instead add a BSP for a different board.
Initially, the server works normally. The client can send data, connect and disconnect. All events are fired normally.But after I send the notification with aci_gatt_update_char_value_ext (data length is 243 bytes and MTU is 300),, it stops handling ...
I've got custom hardware with an STM32WB5MMGH6 micro. I am using STM32CubeIDE Ver 1.16.0.I fetched the BLE_Sensor project to use as a code base for development. I edited the IOC and removed a lot of the peripherals that don't exist on my hardware. I ...
Hello ST experts and everyone,I am a beginner on using the STM32WLE5CC series and need some support.When using the LoRaWAN_FUOTA routine to make a product on the STM32WLE5CCU6 chip solution, DEVEUI, JOINEUI, and APPKEY need to be burned into the chip...
I am working on LoRa-E5 mini. When I try to erase the chip, I receive the error Error: Mass erase operation failed. Please verify flash protection. So I am trying to set RDP on level 0 to 1, but I am getting an Error: Expected value for Option Byte "...
Why this mouse report descriptor is working on nRF52 Nordic Semiconductor hardware and give driver error after BLE HID Bluetooth connection on STM32wb55?[Keyboard report descriptor from nRF52 is working OK]. Report Descriptor should be not dependent ...
I want to use pyocd to write Firmware to M4 of STM32WB5MMG.I am trying to change the range of RDP=BB to RDP=AA and WRP before writing, but it is not working. Do I have to do something special?