Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Yes, I use Cube.In the documentation I read that eMMC is connected to SDMMC1.SDMMC1 can be configured either as SD or MMC. I get the SD option in FATFS only when SDMMC1 is configured as SD.OK, I found the example to use MMC driver, I configured it.An...
I added I-CUBE-wolfMQTT and I-CUBE-wolfSSL software packs to my STM32CubeIDE project in CubeMX built into CubeIDE. In CubeMX I set parameters:for wolfSSL:RTOS - Single THreaded (no RTOS / Baremetal)IO interface - LWIP (native API)for wolfMQTT:FREERTO...
I am using STM32CubeIDE version 1.17.0 and trying to develop a custom board using X-CUBE-DISPLAY with a graphics display using the ST7789V controller. This is a design update for a previous board that was using a 7-segment LCD display. I have a pre...
Hello Guys,I’m working on a project using the STM32F767 evaluation board with STM32CubeIDE and FreeRTOS. In this project, I want to create a .csv file inside the MCU’s storage, write data to it, and then share that file over Ethernet.So far, I have s...
NUCLEO-N6 : I was using UART to transfer a more than 100KB image to the in_buffer in the AXIRAM, so, the HAL_receive itself can not receive so much once, and I wrote a loop function it, to receive it seperately, with every timne 64KB max. And the ali...
I have USB2 OTG high speed port1 working in "device mode" on the STM32N6570-DK board. I need to transfer an image file (around 10 MBytes in size) from the external PSRAM IC (APS256XXN-OBR-BG Hexadeca‑SPI PSRAM) to external PC via a bulk CDC IN endpo...
I'm encountering a networking issue where my STM32 device that is NUCLEO-H755ZI-Q, configured with the LwIP stack over Ethernet without FreeRTOS and assigned a static IP address (192.168.100.123), is unable to be discovered or pinged from a PC connec...
Hello ,I'm working on a STM32F407VET6 board with integrated ethernet port.I'm using Stm32CubeIde 1.18.1 with firmware FW_F4 V1.28.2.I'm just starting out and trying to display a webserver page without rtos for the moment.I've been going round in circ...
Hi,1. I have my own application (migrated from H7 to N6) with FileX writing to the SD card in real-time.And I see that 4-bit data bus is unusable at all (a lot of disk errors).The 1-bit data bus in NORMAL mode works sometimes. HIGH-SPEED is not worki...
The DBATTEN setting in the UCPD_CR register claims the following But as far as I know, the dead battery functionality is always present. It would have to be to work unless this is stored in NVM.Maybe this DBATTEN is some other Rd value? Maybe the ANA...
