Hi All,I am using the P-L496G-CELL02 evaluation kit with the X-CUBE-AWS software to push data to AWS. So far all is good.We tried to get the LPUART up, but don't managed to get the LPUART up and running on this setup. The LPUART initialize correctly...
Posted on April 04, 2018 at 17:00 Hi everybody, I'm currently facing the following problem: I initialize code with CubeMX for a STM32L476JG. I want to use the low level drivers, but they don't seem to work. I was doing several hours of testing...
hello does any one developed a customized bootloader for STM32L051 or similar via LPUART?I didn't find it in Internet.Thank you.
Hy everybody,I have a Nucleo 144-L496ZG board and I test the STM32Cube_FW_L4_V1.13.0 Examples_LL\LPUART\LPUART_WakeupFromStop2 example with IAR. The Tx is working (I see it on the PC's Realterm /TeraTerm) but the Rx doesn't. Even if I do not enter th...
I followed the instruction based on UM2179 User manual section 6.11 (on pp26) LPUART1 communication, "The LPUART1 interface available on PG7 and PG8 of the STM32 can be connected to the ST-LINK or to the ST morpho connector. Another option to do this...
Posted on August 19, 2016 at 06:08Hi,I am using STM32L4 - Vdd @3V (at 48MHz and 80MHz). For both the clock frequencies, i.e. 48MHz and 80MHz, I am able to use the LPUART1 and USB (Device Mode) properly.My RCC configuration is: LPUART1 - LSE Oscillat...