Hello everyone!I read many topics on this forum and it is really helpful but currently I try to solve my problem - unsuccesfully.What I want to do: program MPU through bootloader CANHardware: NUCLEO-L496, STLINK-V3. Crystal HSE soldered on NUCLEO (AN...
I had a hard time the last days struggling with STM32G07 bootloader.Finally I came to this conclusion:I have option bit nBOOT_SEL cleared (unckecked in STCubePorgrammer) and even though this bit is long cleared ie several power cycles have been done ...
Processor: STM32L562QEIBoard: proprietaryWhen connecting STM32CubeProgrammer to my STM32L562QEIx board via USB, I get a Hard Fault interrupt.The USB interface is initialized with MX_USB_Device_Init() and STM32CubeProgrammer correctly detects it. But ...
hey,I went through all possible data sheets I could find did all the required things but my Nucleo still won’t be programmed with uart.I have put boot0 on VDD pin next to it. For confirmation I also put PB2 (nboot1) on ground next to it.I tried power...
Hi,I'm implementing the X-CUBE-STL flash test in a project on a STM32F0 device and using STM32_Programmer_CLI.exe to inject CRCs after compilations to the binary. Compilation runs without any errors/warnings. Running the flash test on the device caus...
As I have seen, an open bootloader middleware is offered for the STM32G4. An FDCAN implementation can be found here. Are there any plans to also offer a pure CAN implementation?I am also interested in whether it is possible to program directly via CA...