Ask questions and find answers on STM32 hardware set-ups, including schematic-related challenges, debugging probes, power configurations, and more.
Hello,Please help me on repairing my St board. Accidently, I gave 9V through the power pins of the board and with no smoke, no sparking, no blast, the board went off. RIP! Now, whenever I try to power on the board using the USB cable, this part (mar...
There is no fully communication with ST-link V2 with STM32 Link utility program.All drivers installed properly, signed. Firmware upgrade mode works, programming mode not.FW version: V2J33s7I set low rate speed 100 kHz, try all reset options - never w...
I've uploaded an Arduino IDE compatible bootloader and I don't want to program it that way any more.
Here is an error: java -jar STLinkUpgrade.jar Exception in thread "main" java.lang.UnsatisfiedLinkError: /Users/yes/Downloads/stsw-link007/AllPlatforms/native/mac_x64/libSTLinkUSBDriver.dylib: dlopen(/Users/yes/Downloads/stsw-link007/AllPlatforms/nat...
I have try to use STM32CubeProgrammer, but it seem do not support ISP mode to program STM target by Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features.But it work with ST-LINK-V3SET.
Hi ,Additional to this I will need some Technical Support on the Board Bring-up . Please forward me the Technical Support Person Email ID .I have a Project using STM32H745XI Micro Controller , I have followed previous known steps to Generate Source c...
Having designed successfully uC Embedded industrial designs since late '70s, I am confused why I cannot make ANY STM32xyyy design without the following problem: A few seconds/minutes after applying power, one ore more I/O lines begin to fluctuate at ...
Hi There,I am having an issue where I cannot disable Read/Write Protection in the option bytes using ST-LINK. Every time I try to disable it for both banks (uncheck the checkboxes and hit apply) I get the following error:Could not set Option bytes!Pl...
Hi all,In STM32L151RDT6, it is initially set to BOR4 (Brown-out reset threshold 4), but I want to run this at 1.8V in the system. Is there any way to launch this at 1.8V and rewrite the BOR level? The solution to this problem can be some HW modifica...
