STM32 MCUs Wireless

[STM32WLE5] RX buffer

Hi!Basing on Ping-Pong example code from CubeIDE I made fw to test WMBUS protocol.Generally works good, but I have some issues:After transmitting data the size of RX buffer is set to size of last transmitted packet. So after transmission of short pac...

Resolved! For those of us interested in supporting an open and competitive world, will you be releasing a even cheaper range of STM32WL sub-GHz MCU's, priced like the TI CC1310 that also includes an SMPS), that does not include the patented LoRa PHY/MAC?

Error in MB1389 (Nucleo WL) schematics

The schematics on page 5 says regarding HSE external""C31 must be placed in orderto avoid stubs on XTA pathwhen C31 not fitted."Probably R41 is meant to be placed.

Resolved! STM32WL55JC not connectable, shows f5 error, but led blink works

I'm not able to connect the NUCLEO-STM32WL55JC1 board (Updated FW today to V3.J7) to the STM32CubeMonitor V.1.1.0 Fun facts: Blink connection test works and the firmware is reported correctly in the connection config box.Error message reads: "not c...

Resolved! When STM32CubeMX will serve STM32WLE5xx ?

I have a mesage from STM32CubeMX: "STM32CubeMX cannot load this MCU" (latest version 6.0.1)

Wen will be available a STM32WLE serie evaluation board?

has anyone have a development board design to test STM32WLE5C8 serie MCU t share?Miguel

Some Guidance with the STM32WLE-chips with LoRa-support

Dear ST-Micro-Team,I have experience with 'other' Microcontrollers, embedded programming and PCB design. However, I'm completely new to the STMicro series with LoRa support.This chip sounds like pure magic, I'd like to try it out.For my project, I'd ...