Hi Team,We are using the STM32WB55 Series for our project. We are using specific flash sectors (8) for our config data. Is there any specific Initializations are required for Flash Operations which is similar to other peripherals like Clock, UART, I2...
HI Team,We are using the STM32WB controller for our project, in that we are using the I2C1 for to communicate with Eeprom Module.Can anyone explain how to configure/Calculate the Exact Timing Register value. If we have any sample calculator for diffe...
I am trying to get the simple ranging example code for the 53L5A1 to work on the WB55RG board but I keep getting a timeout error.The text output the example code outputs is "L53L5A1_RANGING_SENSOR_Init failed. Check you're using ONLY the center devic...
Need the I2C Detailed driver code which contains I2C Read/Write functionalities with DMA.Could anyone provide the code base it useful to us.Regards,Srinivas.V
Hello. I try to use I2C bootloader of STM32WB and it can't connect. I use board NUCLEO-WB55.USBDongle, STLINK-V3SET and STM32CubeProgrammer. I2C: 100KHz Speed mode: standard, addres 0x50. NUCLEO-WB55 I2C pins PB6 PB7, SB6=close, SB2 = open, SW2: BOOT...
Hi,How to use I2C with BLE , I got return HAL_ERROR when I read/write register data from sensor. Thanks.
My STM32WB55 is configured as I2C master and connected to an I2C slave.My I2C block is configured like this:I2C->CR1 = 0x01I2C->CR2 = 0x000A0060 (slave address=0x60 and NBYTES=0x0A)To start the I2C transaction I2C->CR2.START is set to 1.I2C communica...
Hello,I'm using STM32WB55 in conjunction with freeRTOS OSI found a very good I2C BARE-METAL working example located at:..\STM32Cube\Repository\STM32Cube_FW_WB_V1.12.1\Projects\P-NUCLEO-WB55.Nucleo\Examples\I2C\I2C_TwoBoards_AdvComITI'm looking for a ...
I am using the Nucelo board and communicating with an IKS02A1 trough I2C2 using PINs PA11 and PA12 with the following configuration: I have initializaed the I2C folowing the guidelines in "stm32wlxx_hal_i2c.c", and when I use "HAL_I2C_IsDeviceReady()...
My I2C doesn;t seem to work whenever i turn off debug pins in IOC. I used a diff to see the changes but it seems fine to my untrained eyes:$ git diff diff --git a/Core/Inc/sys_conf.h b/Core/Inc/sys_conf.h index 988f1e8..b3cb386 100644 --- a/Core/Inc/...