Hi! Just as a comment, did anyone had that kind of problem?uC is not found or easily losing connection while erase/program.Everything is properly designed and soldered (even programmer pins are temp. soldered to board).Every connection was checked an...
Hello guys. I got two STMF411RE Nucleo Boards and i want to start 10KHz pwm signals on each one of them with 25 microseconds delay between them and i MUST use an external trigger signal (Main synchronization computer) to trigger those STM's to create...
Hello,I have problems with a Custum board with a STM32H735IGK6 controller. I can flash a firmware once, after that I have no connection to the microcontroller and the software does not want to start.Problem description:BOOT0 = VDD--> Microcontroller ...
Hello. I just started with the B-U585I-IOT02A ("Discovery kit for IoT node with STM32U5 series") board. When I run the out-of-the-box demo, plug in the micro USB, and setup the serial port, I can see the "STM32U5 Webserver Demonstration" banner, the ...
Hi,I'm a researcher at MIT and I'm pretty new to the ST world, I'm working on a USB power delivery application for a robotics project where I would like to use an STM32 MCU + an X-NUCLEO-SRC1M1 to deliver 20V over USB-C (as well as data over D+ and D...
Hello I am working on a group project in which we have a Nucleo-H723ZG and a CCA02M2 expansion board. We attempted to follow this quick start guide: https://www.st.com/resource/en/product_presentation/x-nucleo-cca02m2_quick_start_guide.pdf However, ...
Hi, I'm using the LoraWan_EndNode and stop2_mode examples, but either way I can't get the datasheet current, 1 μA, but I managed at most to get 21 μA, and usually around 650 μA. What do I need to do to get the right current?
Perhaps this question was done a lot before, but I saw many topics about it and now I'm confused. Is there any suggestions of what would be the best solution for adding wifi and bluetooth capabilities for a STM32 nucleo board?
I am only used to writing C scripts on RPi, so I'd like to apologize in advance if I left something vague.I was looking to use ISPU for LSM6DSO16IS and the website recommended NUCLEO-F401RE as one of the options for developing the project. I am think...
Hello together,I'm about to design a pcb for my bachelor thesis with a STM32L010 microprocessor.My goal is to connect my pcb via USB-C connector to my host system to program the microcontroller. The programming should happen via the bootloader and it...