Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Hello,I'm using a STM32H743 and IS42S32160 SDRAM. The SDRAM is in bank1, and I followed the instructions on how to setup the external memory from this guide:https://community.st.com/t5/stm32-mcus/how-to-set-up-the-fmc-peripheral-to-interface-with-th...
Hi all, I am using a STM32H747XIH6 MCU. I developed an application using LwIP library. When I connect my circuit directly to the computer, the application works stably. But when I connect the circuit to the LAN network, the application encounters a h...
Edit : see this post for answers :https://www.reddit.com/r/embedded/comments/13rcrqf/stm32h723zg_creating_tcpip_with_lwip_but_cannot/reddit dot com /r/embedded/comments/13rcrqf/stm32h723zg_creating_tcpip_with_lwip_but_cannot/ Hello Summary what I wan...
HELLO, I’m facing a hard fault when transmitting large data (60,018 bytes) via LwIP TCP/IP on STM32H723 with FreeRTOS. After increasing buffers and adjusting lwipopts.h, only 4000-5000 bytes transmit successfully. Remaining data causes crashes, likel...
Hi,I am using the STM32H7R7I8T6 in combination with the Macronix MX25L12833F on a custom board. As I understand it, I need to configure the External Memory Manager and the XSPI interface in STM32CubeMX and after initializing the flash via SFDP, the b...
From my research, I've read that LwIP is written with FreeRTOS, but can be altered to support any OS. Since ST has made an effort to support/encourage LwIP and ThreadX, are there any resources/examples that we can reference?I am doing my evaluation w...
Hi, I stumbled on a little issue regarding DMA2D and a NUCLEO-F767ZI.I used STM32CubeMX 6.13.0, STM32CubeIDE 1.17.0, firmware FW_F7 1.17.2.DMA2D needs RGB888 input color but I configured as RGB565. (I think)The outputs also is RGB565 and seems fine. ...
Hi,I am interfacing my stm32f4 as a modbus TCP/IP client and my laptop act as server(modsim).So i need to give me the best example for that with modbus tcp/IP communication and also provide the portable Modbus TCP/IP stack so i can easily integrate i...
Hello.I have to develop a project with Riverdi STM embedded display (that uses STM32H757). In this project I have to read the USER NAME and the SERIAL NUMBER of GnuPG smart card. I started from AN4800 that is for GSM File system Smart Card but I don...
Hi!I'm working with a STM32C071 and I would like to change uart1 pinout and settings runtime: I've defined USART1 (in the .ioc file) as PB2 (RX) and PC14 (TX). After boot, I would like to change the USART1 pinout as PB6 (TX) and PB7 (RX). So I've wri...
