Hello,As soon as I enable STemWin in CubeMX, I cannot select TrueStudio IDE (see attached screenshot). In the forum, I found other posts with the information that this should work.My CubeMX verion is 4.27.0 (downloaded installer yesterday and tried a...
Hello community,I have a development board with a STM32F429IGT6 processor. I connected an RGB display (without controller) to the LTDC to the board. On the board is too a 64MBIT Sdram on the FMC port. With STM32CubeMX I have been trying to brighten t...
HelloI'm building a first app to explore STem. I'm doing it the easy way :eval F746 and CubeMX.It appears that if I enable STem, Atollic is no more supported as IDE.(see screenshot).Is it a regular behaviour?If yes, can you communicate a reason and i...
Hello, I have succesfully configured several lcd screens with stm32 MCU's, but they always been "timing-friendly" and all the typical parameters were in the datasheet. Now I'm trying to use the 3,5" LCD with HX8238 using RGB 565 connection.Here is th...
up loading the default set values in STM32f746 disco on STM32CubeMx, with following checks :1. Graphics ticked, STEmwin enabled, Guibuilder enabled2. Corrected the pixel resolutuon 480x2723. Execute Guibuilder from within StCube4. FreeRTOS5. As per S...
How do you use control the 7-segment display of the stm32l476-disco board using stm32CubeMX and Kiel? Could someone please help me get a 1 to show on it using this setup?I am able to successfully control it using either GCC or Keil with the example I...
Posted on January 31, 2017 at 06:44 I am trying to make communication between STM32F411RCT6 and character LCD NHD-C0220BIZ-FS(RGB)-FBW-3VM using I2C protocol. STM32 is the master and the LCD is slave device. I am using stm32cubemx and HAL...
I'm trying to generate a STM32CubeMX Project for AC6 but can't find the information necessary to do so. I tried to use the “default mode�?, look for the information inside the (working) BSP code and searched the web for the information or a preconfig...
If I set up an STM32H7-based project (not based on a board) I don't see the 'Graphics' Middleware option. If I set up a STM32F746G-Disco board-based project it appears fine.I'd really like to use the graphics layer, but I need to do so on my own boa...
Hello,I need an SPI Driver for ILI9341. I want to use it with STemWin. Could someone please share the source code if there is any?Best Regards