Hello everyone,I am currently working over stepper motor with STM32F7 series controller and i'm trying to control the stepper using PWM timers. Somehow there is no such support for the same as all i found is controlling servo motor or some other rela...
The Motor Pilot 6.0.0 application is not starting. I have testet it on Windows 10 on a real machine and on a Windows 10 virtual machine. When I start the application the course briefly shows that the machine is working but then nothing happens. No er...
HelloI understand the Nucleo 401 board was developed with the l6470 stepper motor driverI have been trying to interfacel6470 it with the nucleo 446re arm, with very little joy,... actually no joy due to the very poor C code support from ST and the L6...
Hi everyone,I try to get my motor control setup working:Hardware: Nucleo L476RG with ihm16m1 expansion board, motor Gart ML5008 330KV, 24V power supplyI am trying to get my BLDC motor to spin by using motor control FOC library.I generated example pr...
Hello,I have a 48V motor and would like to evaluate this design using the STEVAL-SPIN3201 which is only rated to 45V.The schematic sort of suggests that if you remove the JP2 jumper you can independently supply VM and VBUS, and VBUS can go to 60 volt...
I am using EVSPIN32F0601S1 kit. now i want to read the adc channel 5 value. current amplified single given to adc channel 5(IN5) in my kit. i want to read the value of that adc channel. how can i read adc value ?
This is for a project. I develop a drwaing machine, 2 axis -> 2 steppers for x-y coordinates.
Why do I see an overcurrent error in Motor Pilot when trying to configure my boards for FOC algorithm? I am using the 3-shunt configuration with Hall sensor.
Hello,I am trying to build a BLDC controller using STM32F4. I made a board with the 6 mosfet and drivers, current sensing, Hall sensors input...Is there a ST library for motor control ? I found differents tools (MC workbench), but they seems to be de...