Hello,I am trying to build a BLDC controller using STM32F4. I made a board with the 6 mosfet and drivers, current sensing, Hall sensors input...Is there a ST library for motor control ? I found differents tools (MC workbench), but they seems to be de...
Hello Everyone,I am trying to control an AC Induction motor using the 3 Phase Inverter board "EVSPIN32F0601S1". According to the datasheet of the EVSPIN32F0601S1, it can control PMSM and BLDC motors. But, It didn't mention anything about the ACIM. My...
Hi,Starting from this development board, would like to know if I can add easily encoder (which one) and if there are example project for a servo driver, I mean code to control speed and position of the gimbal motor.Thanks in advance
I am currently trying to compile an image for a qualcomm ESC board (STM32F0xx based brushless DC controller). I manage to build the firmware up to the last step, where the firmware is encrypted using a key. To do this, the make file calls a utility, ...
Hello,We cannot move a BLDC motor (using the x-cube-spn8 demo software with IAR) with STM32F302 and IHM08M1 driver.It attempts to move but is stuck and bound up. Once in a while immediately on starting app it would move a few revolutions before bind...
I have designed a custom board based on STSPIN32G4 schematic but with an automotive mosfet (iaua200n04s5n010auma1).Everything works except that the controller enters an overcurrent fault every time i start the motor pilot GUIDoes this have to do with...
I have some drivers left from a few months ago, and they are working with no problem. This same project loaded to the new boards and everything works O'K except that the packets don't flow (neither way).I've tried to reset and set the CAN_SHDN (PC11)...
I'm using motor profiler for the motor control. I have the following hardware components:STM32 Nucleo-F4446REX-NUCLEO-IHM16M1Mitoot motorIn the motor profiler, it mentions that IHM16M1 can only work sith STM32 Nucleo-G4 and that F4 and IHM16 combined...
I have designed a custom board based on STSPIN32G4 schematic but with an automotive mosfet (iaua200n04s5n010auma1). Everything works except that the controller enters an IDLE STATE and STOP STATE every time I tried to run the motor.Does this have to ...
I am attempting to use an STEVAL-SPIN3201 eval board for the first time but cannot get it to enumerated on USB. LD2 flashes slowly indicating the embedded ST-LINK is operating. I have tried installing the Windows driver using en.stsw-link009, but no ...