About ABart.5

ABart.5 · 2023-05-01

I'm trying to use the Motor Profiler software through my Motor Controller SDSK 6.1.1. When I launch the profiler, I Select my boards - Nucleo-F302R8 and X-Nucleo-IHM07M1 3Sh. Then I set the motor parameters to match my motor Bull Running BR2804. When...

ABart.5 · 2023-04-26

Why do I see an overcurrent error in Motor Pilot when trying to configure my boards for FOC algorithm? I am using the 3-shunt configuration with Hall sensor.

ABart.5 · 2023-05-01

https://community.st.com/s/question/0D53W00002A1SntSAF/st-motor-pilotprofiler-will-not-connectThe solution on this post helped. I reinstalled the SDSK 6.1.1 at a different location than the default in Program Files.

ABart.5 · 2023-05-01

I can see the ST-Link in the Device Manager.I have the right drivers.I can connect to the STM32 using Cube Programmer. Motor Pilot also connects and I can start/stop my motor using the software. I don't see any updates that are needed on the boards.

ABart.5 · 2023-04-26

Were you able to figure out the problem? I'm having the same issue.

User statistics

User Activity

Motor Profiler stuck on "Checking ST-Link connection"

Using FOC Algorithm with Nucleo-F302R8 and IHM07M1 (3 shunt) gives Over Current error in Motor Pilot when Motor is run

Re: Motor Profiler stuck on "Checking ST-Link connection"

Re: Motor Profiler stuck on "Checking ST-Link connection"

Re: I am Using X-nucleo-ihm07m1 along with nucleo-f030r8 for controlling a bldc motor. once my motor enters in FOC Mode it shows over current error. what Could be a possible reason? What Can I Try